Loadstar-sensors LoadVUE-CG (Center of Gravity) Manuel d'utilisateur télécharger pdf

Quick Start Guide for LoadVUE-CG

1. Install LoadVUE-CG first. This will also install the drivers needed. (The drivers can also be

installed by downloading and running

http://www.ftdichip.com/Drivers/CDM/CDM20814_Setup.exe)

2. Connect all the four load cells to the computer’s USB port (using a hub if necessary).

3. This will add 4 USB Serial Port entries to the Device Manager, one for each load cell.

4. Run LoadVUE-CG by clicking on the LoadVUE–CG shortcut on the desktop.

5. LoadVUE-CG will scan the USB ports for connected load cells.

Note: A unique identifier is assigned to each load cell/interface unit. The software uses these

identifiers to locate the load cells correctly on each corner of the scale. (For example, if the

identifier begins with “BL…” then the load cell is assumed to be on the bottom left of the scale. If

the identifier begins with “TR…” then the load cell is assumed to be on the top right of the scale.)

6. LoadVUE-CG main screen is then displayed. The various parts of this screen are identified below.

Toolbar

Total Load Unit

selection

Load cell identifier

CG coordinates

Serial Port Numbers

Load on each

corner of the scale

Total Load

Location

1 2 3 4

Page 1

Quick Start Guide for LoadVUE-CG 1. Install LoadVUE-CG first. This will also install the drivers needed. (The drivers can also be installed by downlo

LoadVUE-CG User Guide Loadstar Sensors, Inc. • www.loadstarsensors.com 7. Click on Setup…COM Ports Setup… on the toolbar to configure the dimensions

Page 3

• 2 Loadstar Sensors, Inc. • www.loadstarsensors.com 11. Click on Log View -> to switch to the log window. 12. In this view, o Check the Lo

Page 4

LoadVUE-CG User Guide Loadstar Sensors, Inc. • www.loadstarsensors.com

Pas de commentaire

Loadstar-sensors LoadVUE-CG (Center of Gravity) Manuel d'utilisateur